Chapter # 10
Faults & remedies of microhydel power projects
Hi visitors, In this chapter, you will go through the faults which occur in Microhydel Power Projects during their operation. These faults are of different types and may occur at any time. As discussed in previous chapter (Chapter 9), the operator should check the whole system and its mechanism of operation before starting the project for operation.
He should be very careful about the system and specially its mechanical parts, like belts, pulleys and shafts and never touch any moving part when the plant is in operation. He should just monitor the system for any unusual movement or vibration.
As mentioned early in previous chapters, these are microhydels means very small units, just like a kid and a kid always acts according his or her will and if you want to take any work or assignment from your kid then first you have to motivate your kid for the task. You have to fulfill his or her demands if he or her asks from you'
Microhydel Power project is just like a kid, it demands to close monitor each and every item like, from grease to cleanliness of different electrical and mechanical joints before, during and after operation of the system.
Each and everything relating the faults & remedies of the plant has been described in the chapter in consideration in tabular form. Go through the chapter thoroughly, Note down points of interest with the help of your pen on a paper.
The English is very simple and in my opinion a person who has done his matriculation or having a diploma can understand this simple English. The main task for you to get access to the Chapter is to just go to the link shared below and click the link and you will get access to the Chapter.
At this time you will not see the link because you are in the middle of the page. Just scroll down the page and you will see the link at the bottom of the page. Your one finger click will take you to the Chapter. Therefore, hurry up and tap the link shared below.
Click:
